 |
The ALZO 100
macro studio includes: 2 ALZO 100 lights, a camera support and a 10" ALZO
imaging tent. (camera shown is not included) |
 |
1)
Attach the vertical post to the camera support base with the bolt and
washer provided. The vertical post should tilt over the platform. Do not
over tighten the bolt. |
 |
2)
Attach the camera support lock wing screw to the back of the camera
support. The assembly of the camera
support is complete. |
 |
ALZO 100 LIGHT ASSEMBLY
3) Tightly fasten light
support posts to base plates. Slide Socket assemblies onto light posts and
secure with wing screw.
An extra light support post is supplied that
can be attached to the top of one of light support posts to allow for
additional height for top illumination of some subjects. |
 |
4)
Attach O-Ring to base of the bulb as shown.
5) Slide the aluminum
reflectors over the base of the light bulbs until snug. Holding the glass
of the bulb, screw in the bulbs with reflectors into the socket assemblies
until JUST SNUG.
Do not over tighten the bulbs. Over
tightening the bulbs will damage the socket and the bulb. |
|
 |
6)
Secure the camera quick release plate to the base of the camera. The
quick release plate is released by rotating QUICK RELEASE LEVER into
"hold open" position. The Plate attaches to a camera with provided
universal threaded screw mount and then snaps into position on camera
support. QUICK RELEASE LEVER then closes and can be locked with QUICK
RELEASE LATCH. 7) QUICK
RELEASE LATCH -
The latch is used to lock the QUICK RELEASE LEVER from opening
unintentionally, thereby preventing camera accidental detachment from
tripod. Normally this latch is in the released position.
Once the camera is in place on the tripod,
moving the QUICK RELEASE LATCH to the locked position will prevent opening
the QUICK RELEASE LEVER and removing the camera. |
| |
|
|
