 3)
Back-out the Light Stand Lock Wing
Screw and then mount the ALZO 250
light to the top of a light stand
and tighten the Light Stand Lock
Screw to hold the light firmly to
the stand.
4) Carefully
screw in the light bulb into the
socket until JUST SNUG. Do not over
tighten the bulb. Over tightening
the bulb will damage the socket and
the bulb.
5) To
assemble the umbrella to the light,
first insert the shaft of the
umbrella through the hole in the
reflector and then into the
umbrella mount hole on the Socket
Assembly. Lightly tighten the
Umbrella Lock Screw (not shown). |
1)
Place the dome reflector on a flat
surface with the notch in the top
hole facing forward. Attach the
socket assembly by aligning the
Mounting Pins on the reflector with
the socket assembly and rotating
the socket assembly to the locked
position.
2)
Tighten the Lock Screw through the
Socket Assembly and into the notch
in the Dome Reflector. This will
prevent the dome reflector from
separating from the socket
assembly.
