ALZO 300 LIGHT ASSEMBLY

1) Place the dome reflector on a flat surface and attach the socket assembly by aligning the Locking Nut hole and Mounting Pins and rotating to the locked position.

2) Thread the LOCKING NUT through the Socket Assembly and into the Dome Reflector, and tighten lightly. This will prevent the dome reflector from separating from the socket assembly.

3) Mount the ALZO 300 light to the top of a light stand and tighten the wing nut to hold the light firmly to the stand.

4) Carefully screw in the three light bulbs until JUST SNUG. Do not over tighten the bulbs. Over tightening the bulbs will damage the socket and the bulb. It is normal for the bulbs to touch each other.

5) The fabric diffuser is optional and is typically not used if the ALZO 300 light is being used with a Cocoon or Tent. The diffuser is easily attached when the light is attached to a light stand.  Attach the fabric diffuser by stretching the black mesh outer ring over the reflector edge. Start at the bottom and work up the sides and over the top edge.